AGILE ALLY PLUS 6287 Uživatelský manuál stáhnout pdf (Strana 37)

Page 2-13INSTALLATION

Alternate Host Verification

Test the alternate host by sending a Print Screen job (or device equivalent)

from the alternate host to the current printer attached to the ALLY PLUS.

Refer to the alternate host system documentation for instructions on sending

a Print Screen command.

If it does not print:

 Check that the alternate host is powered on and securely connected

to the ALLY PLUS with AGILE-approved cables or cable adapters.

 If using a serial cable, check the General Configuration Report, and

make sure that the Option Group #40 settings (Options 41-45 for

SERIAL 1, Options 47-4B for SERIAL 2) match the serial interface

settings for baud rate, parity, word length (data bits), stop bits and

handshaking. The default settings are 8 data bits, 1 stop bit, no parity,

9600 baud and RTS/CTS flow control. Refer to Section 3  Con-

figuration for detailed instructions on configuration, and change the

settings as needed.

Contacting AGILE Customer Support

If a problem persists after each of the potential problems listed above has

been checked and corrected, call AGILE customer support. Please have the

following information available before calling:

A printout of the General Configuration Report, if able to print one using

Mode 5 from the front panel.

6287 ALLY PLUS serial # (found on the bottom panel): S/N

Firmware version #

(found on the bottom of the external ROM cartridge):

Cluster controller model #:

SCS or DSC mode:

Printer or plotter make: Model #:

Printer/plotter cable #:

Plotter graphics software name:

Parallel or serial interface:

If serial: Length: Stops:

Parity: Baud:

Flow control:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 185 186

Žádné komentáře

AGILE ALLY PLUS 6287 Uživatelský manuál Strana 37